Get matched with top Home Security Companies in Littleton

There are 36 highly-rated local home security companies.

Home Security System reviews in Littleton

  • A
    Mountain Alarm
    It went well. The same company, by a different name, installed the security system 14 years ago. I wanted it updated. The update works well with the expected improvements, Staff at the office is always friendly and helpful. When something is not done right with the system (someone does not use it properly and does not know the security word) they take the proper actions.
    - Cynthia J.
  • A
    Security Central Inc
    Been with SC a long time now, finally needed service and it went flawlessly, Curtis couldn't have been more helpful even answering questions about the phone application available to us. Great customer service!
    - Nathan S.
  • B
    SimpliSafe Home Security
    I just ordered some stuff that they delivered to me. Overall is just good I  mean they were it was easy to install I mean they sent everything it showed up it was easy to itself to install so no major issue I didn't have to talk to them much so.
    - Michael T.
  • A
    Colorado Security
    He was the most reasonable cost of everyone I called. There was no 2 hour appointment window or hourly minimum, he just showed up on time at the time I needed him. He understood the urgency of the repairs I needed so made time for same day repair. He was quick and knew exactly what he was doing. He even left us with extra parts and trained me on how to do the repair myself if I ever needed to. We would definitely use him again.
    - Marcus M.
  • A
    SimpliSafe Home Security
    There is a keychain which can set or stop the alarm and a panic button which can be used in emergency

    |One small problem:  the screws are a little too small and sometimes do not hold the equipment properly

    |Otherwise it is a system that you can take w you where ever you go
    - Ellie W.
  • A
    I researched the company on Angie's List and then called to get a little bit more information. They were very helpful and patiently answered all my questions. When we were ready to buy, they helped us use the deal on Angie's List and supplement it with more sensors. Everything arrived promptly and well-packaged. It was very easy to install the sensors. We had to call back one time because one sensor wasn't working, but they got it programmed and in working order very quickly. Everyone I have talked with on the phone has been polite and very helpful. Also, they have taken plenty of time to explain and answer questions.
    - Mary D.
  • F
    ADT Security Services Inc
    The sales relocation rep Robin Lowman (whom we had used previously) and arranged for all of our services. Te technicians came out promptly and did a good job. We paid the technician for the entire service while he was still in the house. The check cleared and the money was removed from our account the following day. We signed up for automatic payments for our service so that ADT was assured of getting their payment on a regular monthly basis. The $1108.75 payment we made to ADT has somehow just disappeared in thin air. ADT still has our money and we are continuing to be billed for that amount, even after many phone calls to their credit dept. No one there ever has a clue about where the money went. Now to add insult to injury ADT is threatening us that we have a late payment outstanding. Are you kidding? We no longer feel that ADT is offering any security. They can't even get their billing straight. We would definitely encourage using another security company. There is no service after the sale and their billing dept. is a joke. A very quick way to ruin your good credit history!! Run - don't walk away from ADT!!!!
    - Susan W.
  • A
    Everything was easy.  All the people, both on phone and service people, were very friendly and very professional. The system is so easy to use but you can call anytime with questions.  We never imagined this whole process would go so smoothly.  I also received a phone call from United Securities reminding me to notify our homeowners insurance company as we are eligible for a credit for having an alarm and smoke detector with the alarm.  This company is an A+!
    - Kathryn D.
  • A
    SimpliSafe Home Security
    Purchased a home security system with a custom mix of sensors. Sensors are all wireless and so is the base station and the keypads and keyfobs. The basic system uses a GSM cell connection to monitor the house. The monitoring fee is significantly less for the same level of service than some of the other providers and no contract is required! The TMobile coverage at my house was not good enough to make the GSM cell connection (even though on-line coverage maps said it should be). After trying for a week to get this to work, Simplisafe provided an interface to go into the broadband connection in my house and then all problems were eliminated. I am very happy with the app on my Droid smart phone that allows me to remotely arm/disarm and see system status. The mix of sensors is very good but am waiting for the release of a compatible smoke detector and glass breakage sensor. Both are due out soon. The company estimates that the batteries in the wireless sensors are generally good for 5 years of service. I used this system to replace an old hard-wire system that I installed years ago. This system is much smarter and with with the internet connectivity, works very well regardless of where family members are. I would recommend this system and provider to others. The self-installation part was trivial.
    - David B.
  • B
    I started writing this as a suggestion to save the reader time while getting the most that FrontPoint has to offer, so it IS what I did, just written in an expository style.
    Look at the videos on the FrontPoint site BEFORE calling. Keep track of your questions so that you can minimize the time spent in talking with George Jorro (if you contact him directly) or whatever CSR you speak with (if you call the main number). Start here: There is a video embedded in the first page which gives a quick overview. Videos specific to different parts of the system can be accessed here: There are not videos for every sensor or control, but the main ones are covered.
    If you have a blueprint or schematic of your dwelling/property, it will make it much easier to plan how many sensors you will need for your peace of mind. I am more concerned about security when I am sleeping, so a secure perimeter was what I wanted. It seems that many people care about their stuff when they are gone, so for them, 5 or 6 sensors might do the trick.
    Read through the manuals BEFORE starting your installation. Then think about what you want to accomplish and what level of security you want. We had access to the condo starting Monday afternoon. The FrontPoint package arrived Monday afternoon. After move-in, late Monday, I opened the box and pulled the booklets which describe installation, things to watch for and operation of the parts of the alarm system. The booklets offered a static, step-by-step guide which was familiar because of the time I spent watching videos on the site.
    Tuesday afternoon, I laid out the sensors in order underneath the doors and windows they would be used on. Environmental sensors were stacked in the hallway near the heater. [You can waste an hour on the internet researching and understanding the physics of CO dispersion in air at a normal indoor temperature, or you can just mount it near the smoke detector on the hallway ceiling.] Sensors  are numbered (box and sensor), and the booklet suggests a general order to follow (doors are assigned the lowest numbers for example).
    Tuesday evening I mounted three door sensors and one window sensor. It was a challenge getting the garage door sensor mounted as the door was metal, the temperature on the other side of it was 16 degrees F., which made the adhesive somewhat ineffective. I found that using Everclear 190 proof alcohol worked wonders as a preparatory solvent for the adhesive, but a powerful hair dryer to heat the surfaces on which I mounted sensors would have speeded things along. Positive benefit of the low temperatures was that some relocation of the sensors could be done if they had not been pushed down and held in place for a few moments. Even after using pressure on a sensor, it could sometimes (50/50 chance) be removed by slipping a sharp knife between substrate and adhesive and prying the adhesive up S L O W L Y.
    I had purchased some 3M Command refill strips (eight packs of the small ones, and two packs of the large ones) just in case I got into relocation problems. Turned out that I used these mainly to position magnets and sensors at the same level. Glad I had them, but next time would buy the new Industrial Strength 3M Command Strips.
    Had only two problems requiring a call to technical support. One easy, the other not so much.
    The glass-break sensor was partially open when removed from the box. Opened as in the box had suffered enough of a shock that it knocked the sensor open as if one was going to replace the batteries (there are two), and the printed circuit board was askew. I put everything back together and it seemed to be functioning correctly, but I asked tech support about a screw with a spring attached which turned out to be the tamper switch, not a sensitivity adjustment. No problem in other words.
    As soon as I connected the Control Panel (and BTW - you can do this immediately since nothing is externally active until you call FrontPoint), the Garage Door Sensor gave a low battery indication. I should have called tech support immediately, but made a wrong assumption that the sensor was so far away from the Control Panel that it was indicating low battery, because why would anyone ship an old battery in a new system? Thursday evening, everything except the environmental sensors was installed and working. I moved the Control Panel close to the garage door sensor and it STILL gave a low battery indication. The next morning, I called tech support and spoke with CJ. He described functionality of glass break and set my mind on ease about that. As for the Garage Door Sensor with the low battery, he suggested that the battery may have become dislodged, or even have some dirt under a contact, so I should open it up and pull the battery, wipe it off, and then reseat the battery. Now I have dealt with coin batteries for decades. Garage door sensor uses either CR2016s or CR2025s - don't remember which. I could NOT get the two wings holding the battery to yield enough to release the battery from the holder, UNTIL one of the little plastic wings broke completely off the battery holder.
    When I wiped the battery and put it back in the sensor, the low battery indication was gone, so Tech CJ had correctly diagnosed the problem, but now I had a (supposedly) new alarm sensor with a broken battery holder.
    I called back to tech support and got a woman (whose name I wish I had, but alas it is written in a place I will not be able to access for another three weeks, and I want to finish this review and get on with life) and described the previous conversation with CJ, the fact that it was VERY cold where I was, that we did NOT know if the battery case was cold-cracked in shipping and was already compromised giving the low battery reading or what, but that I needed a replacement garage door sensor. I was put on hold for 15 minutes. She came back and told me that she, "thought the sensor would be OK to use" with the broken part. I told her that I had not called in looking for assurances that my security system MIGHT be OK, but rather had called in asking for a replacement for an item that had indicated defective from the beginning, that this was my fourth security system, that I had not spent $1134 on sensors and committed to a $42/month contract to MAYBE be OK. I was put on hold again. Twelve minutes later she came back on the telephone and told me that I would need to pay for the replacement sensor. I told her thank God there was a thirty day satisfaction guaranteed policy because it was all coming back.
    I asked how long she had been with FrontPoint and she answered "awhile." I asked her how long a while and she would not answer, so I asked for her supervisor. She told me he would not be available, and I said I would wait until he was and was put on hold again.
    Eight minutes later she came back on the telephone and told me they would ship a replacement sensor at no charge.
    So BUYER BEWARE. If something is wrong, call immediately. It would have been a serious PITA to pull down all the sensors and go to a competitor. Had this call to tech support have happened on the frontend of the install, there would have been no question in my mind about returning the system, though because of his outstanding customer service, I would probably have called George Jorro to make sure that I was going to be asked to keep a defective sensor.
    Loved the customer service experience with George; comparatively speaking loved the price compared to high pressure techniques and overselling big systems from some of the big companies, loved my conversation with Tech CJ, but HATED MY LAST customer interaction. I mean REALLY?
    - Keith D.
Join Angie's List to view provider's name.
Join Angie's List Now To see all 36 highly rated companies in Littleton

Explore Our Solution Center for Helpful Alarm System Articles

Go to the article: 

DIY Home Security Systems Provide Personalized Protection

Motion lights and camera on the side of a home
Go to the article: 

How Much Does it Cost to Install a Home Security System?

Security system panel
Go to the article: 

10 Questions to Ask Your Home Security Provider

home security technician with client

Home Security Companies in Littleton

Companies below are listed in alphabetical order.

To view top rated service providers along with reviews & ratings, JOIN ANGIE'S LIST NOW!