I love this company. Buying a metal roof from Dallas Metal Roofs is one of the best decisions I've ever made. This company doesn't use snap-on metal panels like so many other metal roofing companies. Those snap on metal panels can blow off in heavy winds. I've seen it happen. Dallas Metal Roofs installs your metal roof with old school craftsmanship. They showed up with 4 heavy rolls of galvalume metal. They unrolled the metal and cut panels designed to fit my roof. The machine that unrolls the metal also crimps the sides of each cut panel. This will be your "seam" on your standing seam roof. They neatly stacked all these cut, crimped panels far enough away from my garage so I could still use my garage. This whole process took about 4 hours. The next day, a crew of 2 men showed up to tear off my old asphalt shingle roof. After tearing off my old roof, they applied a rain barrier to protect me from storms while the roof is being put on. The same 2 man crew came every day to install the cut, crimped metal panels on my roof. You wouldn't believe the skill of these two craftsmen. They installed my standing seam metal roof one crimped metal panel at a time. They precisely cut each panel to fit a specific section of the roof. The install the panel. They then install another precisely cut panel side by side next to it and then they crimp by hand the two panels together. Each panel is precisely cut, installed, and hand crimped until the entire roof is covered. They then metal capped all the ridges and hips until I had a finished roof. I had a lot more flashing challenges than the average homeowner. I had 4 solatubes, 3 solar fans, a chimney, 2 skylights, 3 pea traps, and 1 kitchen stove vent. The 2 man crew flashed everything perfectly. I've had my roof almost 2 years and there are no leaks and there never will be. Standing seam metal roofs must be flashed properly and many metal roofers don't properly flash roof fixtures, causing leaks. You won't have this problem with Dallas Metal Roofs. Many neighbors would come outside and watch the 2 man crew from Dallas Metal Roofs. It's not every day that you get to see old world hand craftsmanship. One of my neighbors was so impressed, he purchased a roof from Dallas Metal Roofs also. My mom also bought one. A standing seam from Dallas Metal Roofs only costs slightly more than an asphalt shingle roof. This is because Dallas Metal Roofs starts with a simple heavy roll of metal. They unroll, cut, crimp, manufacture, install, shape, fasten, trim, and mechanically lock everything themselves. They don't buy preformed snap-on panels which would cost you more money. This savings gets passed on to you and the old world craftsmanship quality is superior to preformed snap-on panels. I have no regrets contracting with Dallas Metal Roofs. Neither does my mom or my neighbor. My metal roof also qualified me for a substantial homeowners insurance discount. One more point I want to make. A standing seam metal roof is THE most solar panel friendly roof you can buy. Solar panel brackets can be easily attached to the seam of these roofs without drilling holes. Adding solar panels to asphalt shingle roofs is illogical. Solar panels can last 25 years. Asphalt shingles typically last around 15 years or less here in North Texas. Every time you replace your asphalt shingles, you must uninstall the solar panels. This will add enormous labor costs to future asphalt shingle roofs that you buy in the future. A permanent standing seam metal roof is the best first step you can make before considering solar panels. You won't find a better contractor for standing seam metal roofs than Dallas Metal Roofs. This is truly the last roof you will ever buy.