What's the Best Lighting for My Kitchen?
THE Cost of the recessed light is largly determinate on Where ,You purchase the product and the number you buy .Big Box dicount stores have products made oversea's that are less expensive than those found at Custom Bath & Kitchen Stores , but the products are often riddled with problems , missing parts , defects etc,
A typical light will run $ 35.00 to $ 85.00
However , the true cost of recessed lighting is involved in getting circuits or circuity to the switch and lighting system .In NEW construction , this matter is easily dealt with by installing circuits and hardware during framing . Whereas , with remodeling , installing new lighting into existing spaces , requires wall & ceiling opening ,closure , repair , repainting & finishing
I have been involved in projects where the lighting cost but $500.00 ,,
while the installation & finishing costs exceeded $ 2500.00
Here is about the same question (for 1 fan) a while back, with answer:
Your total cost could be from 1.5-3 times that shown in the answer, depending on how much of the wiring for the three fans he can combine - i.e. can he easily run one power circuit for all 3 fans, then just tap off that for switches and runs to the fans, are they fans only or with lights (double the wiring and switches), etc. Note the costs do NOT include drywall/panelling repair or painting to match. Also, you are going to be near the top end of the estimates, because in all probability your access is poor, and 3 fans are almost certain to require a totally new run from the breaker box.
Unless you have an open exposed-joist attic above where the fans are to go AND the top of the walls the switches will go in, you can expect substantial holes in walls and ceiling to pull the wires and fasten them - by code, you cannot just pull wires between joist and let them lie on the top of the ceiling drywall - you have to staple them to joists every few feet, so you end up with several 1-2 foot holes typically near top of the wall (to drill through top plate), near side of ceiling to grab and bend wire coming up wall, and maybe one mid-ceiling to reach in and fasten wire, then of course the two openings that are ultimately fully concealed by the switch plate and the fan mounting plate or dome.
Before you get into this project I would check with the condo management if you are allowed to do this - there are limits to how much you can modify your condo and how much you can modify or add in the way of electric circuits.