Angie's How To Properly Hang Framed Pictures and Art

Date Published: Nov. 12, 2019

Difficulty:33%
Time: 15 Minutes

Hanging a framed picture may seem like a simple home maintenance project, but it's easy to make a few small mistakes that leave your art crooked or hanging at the wrong height. In the worst case scenario, your art could fall off of its mount and leave a nasty hole in your wall!

Tools & Materials Needed 
hammer
level
stud finder
measuring tape
pencil
small nails (or dome head screws if hanging heavy artwork)
1Decide what type of nail you want to use to hang your picture or art.

For lighter artwork, a single 1-inch or 2-inch finishing nail should support your frame. For heavier pictures, round head screws (also known as dome head screws) provide more strength and are a better choice.

Local resource: Handymen near me

2If you have a stud finder, use it to locate the studs in your wall.

Hanging your artwork on the stud will offer extra support and take some pressure off of the plaster part of your wall. Stud finders generally cost $20-$50, and are available at your local hardware store. Studs are usually spaced 15 inches apart from each other, so the chances that you'll find a stud by luck are pretty slim. If you don't have a stud finder, you can still hang your art! For lighter artwork, it's fine to just hang them between studs. If you're hanging a heavy frame between studs with a dome head screw, you can safely hang your photo by purchasing a hollow-wall anchor. These can be found at your local hardware store for around $10.

3HANG YOUR ART AT 57" ON CENTER

This means the center of your picture or wall art should measure 57" from your floor. Don't feel like you must hang your art at this height. If your space or setup doesn't accommodate a 57" height, improvise!

4Measure from the top of your picture to its center

Or measure the height of your picture and divide it by two. Then, hook your measuring tape to the hanging wire (or whatever hook you are hanging your art with) and pull it upwards until it's tight. Next, measure the distance from the wire to the top edge of the frame. This is usually about 2 or 3 inches. Subtract this amount from the number you got when you measured the height of half your picture. This will tell you how far above the 57" mark you will need to place your nail so that the center of your photo will still be at 57ӝ. Once you've measured this distance, lightly mark with a pencil where you will place the nail.

5Hammer your nail, screw or hollow-wall anchor into your pencil mark.

If you're hanging pictures in between studs, hammer your nail at a steep angle of at least 45 degrees for extra support.

6Hang your photo and grab your level.

Place it horizontally on top of your frame. The horizontal tube should be parallel with the top edge of your frame. Inspect the tube. If the bubble is in the center of the tube between the two lines, your picture is straight!

What is Angie's List?

Angie’s List is the trusted site where more than 6 million households go to get ratings and reviews on everything from home repair to health care. Stop guessing when it comes to hiring! Check Angie’s List to find out who does the best work in town.

Local Discounts

Daily deals up to 70% off popular home improvement projects from top-rated contractors on Angie’s List!